2002, Volume 4, Issue 6
Strategic Study of CAE >> 2002, Volume 4, Issue 6
Application of PCI Bus in the Numerical-Control-System
Laser Device Section , Institute of Precision Instrument , Tianjin University , Photoelctricity Information Technology & Science Education Department Key Laboratory , Tianjin 300072, China
Next Previous
Abstract
PCI bus has become the primary bus standard of PC. It is widely used in numerical-control-system ,such as 3D laser formation, high speed laser marking, laser cut and so on. This article analyzes several technique problems and puts forward solving strategy. A graphic processing card for high speed laser marking machine has been designed, which can raise the efficiency by 25%～30%.
Figures
图1
图2
图3
图4
图5
图6
图7
图8
References
[ 1 ] 曾凡太, 李洪珍.PCI总线发展概况[J].计算机世界, 1996, (7) :101
[ 2 ] 曾凡太, 陈美金.PCI总线产品的开发[J].计算机世界, 1996, (7) :109
[ 3 ] ShanleyT , AndersonD .PCIsystemarchitecture[M ].SanFranciscoMindshare, Inc., 1997
[ 4 ] 李贵山, 戚德虎.PCI局部总线开发者指南[M ].西安:西安电子科技大学出版社, 199 link1
京公网安备 11010502051620号
